Right grip permanently glued to the throttle grip Left grip with aluminum clamping ring for fixing on the handlebar Inconvenient gluing and secur...
Provides optimum protection For rear sprockets up to 50T and 220 mm - 260 mm brake discs.
Use this to remove the dirt from your last mud battle with ease! A motorcycle grip rubber (not included) can be fitted to the grip.
Magnetic. Never lose a bolt again! Perfect for use in combination with the SX stand.
100 mm length 20 blades: 0,05 - 0,1 - 0,15 - 0,2 - 0,25 - 0,3- 0,35 - 0,4 - 0,45 - 0,5 - 0,55 - 0,6 - 0,65 - 0,7 - 0,75 - 0,8 - 0,85 - 0,9 - 0,95...
Right grip permanently glued to the throttle grip Left grip with aluminum clamping ring for fixing on the handlebar Inconvenient gluing and secur...
Provides optimum protection For rear sprockets up to 50T and 220 mm - 260 mm brake discs.
Use this to remove the dirt from your last mud battle with ease! A motorcycle grip rubber (not included) can be fitted to the grip.
Magnetic. Never lose a bolt again! Perfect for use in combination with the SX stand.
100 mm length 20 blades: 0,05 - 0,1 - 0,15 - 0,2 - 0,25 - 0,3- 0,35 - 0,4 - 0,45 - 0,5 - 0,55 - 0,6 - 0,65 - 0,7 - 0,75 - 0,8 - 0,85 - 0,9 - 0,95...
Tool for pressing in components (heim joint)
Tool for clamping components (fork legs, outer fork tube)
Tool (including chassis, crank rotation mechanism, oil pan, and engine bracket) for mounting the rem...
Tool for securing the removed engine on the engine work stand
Tool for securing the removed engine on the engine work stand
Torque wrench with various bits in the kit for tightening fittings to tightening torque (spokes)
Tool for checking the X dimension (piston protrusion)
Tool for disengaging components (sections of the engine case)
Tool for pulling off components (primary gear wheel, sleeve, main shaft, rotor)
Tool for protecting components (when disengaging the sections of the engine case)
Sleeve with cover used as insert in the pressing tool for pressing the crankshaft together
Tool for separating the crankshaft
Anchor plate for screwing on to the pressing tool, for pressing the crankshaft together
Tool for loosening and tightening components (screw cap)
Tool for driving components out (collar bushings)
Tool for removing and installing components (DU bush)
Tool for loosening and tightening components (screw cap)
Tool for holding when assembling fork legs
Tool for protecting components (inner tube)
Tool for loosening and tightening components (sliding bushing support)
Tool for bleeding and filling dampers
Tool for removing components (rebound damping adjustment of piston rod)
Adapter for filling tool for filling the damper with nitrogen
Tool for tensioning and releasing the springs (2 units)